Worldwide side 1970

Company certified according to ISO 9001:2008

SINCE 2007 HEAT TREATMENTS OF HIGHER QUALITY

Thanks to the company RHT in Borgonato di Franciacorta we offer heat treatments on behalf of third parties, such as hardening and gas nitriding!

Opening hours
Lun-Ven 8AM-6PM
HEAT TREATMENTS AT 360 DEGREES
Since 2008 the company RHT performs heat treatments of mechanical parts. It is specialized in induction hardening and gas nitriding, always with particular attention to feasibility and to quality control.

HARDENING AND NITRIDING

The RHT has its main office in Borgonato di Franciacorta (Brescia) and occupies 2500 square meters, with a covered area of 1000 square meters. In this facility the company performs heat treatments of mechanical parts.

The company has 5 plants dedicated for induction hardening with strengths from 55 to 250 kw and frequencies from 4 to 300 kHz which allow depths from a few tenths till maximum 10mm. 2 electric ventilated ovens permit quenching till 500 degrees.

The gas nitriding department has a vertical chamber oven with dimensions of 1200x1900 and productive capacity of 3000kg.

Certified heat treatments

The company RHT has been certified according to ISO 9001:2008 since 2009. That’s the official award for the high quality standards guaranteed by the company located in Borgonato di Franciacorta on heat treatments, both induction and in atmosphere.

OUR HEAT TREATMENTS:

INDUCTION HARDENING

One of the heat treatments offered by RHT is the induction hardening. We guarantee strengths from 55 to 250 kw and frequencies from 4 to 300 kHz. We are waiting for a new machinery which will cover a range of products of considerable sizes.

GAS NITRIDING

Another kind of heat treatment offered by RHT. The oven used for gas nitriding of mechanical components in steel has a productive capacity of 3000kg.

QUALITY CONTROLS OF HEAT TREATMENTS

The available equipment allows to control the processed material, checking its quality. More specifically, the company RHT has at its disposal:

  • - Bench magnetoscope (CGM Srl mod. magiscop type cem 1500/1, with the possibility to check axletrees with diameters up to 400mm and lengths up to 1500mm)
  • - Microdurometer mitutoyo mod. mvk-h1/810-118
  • - Bench hardness tester ernst mod. at130dr
  • - Hardness tester brinnel 10/3000 lonos test
  • - Portable hardness tester proceq. Mod. equotip
  • - Portable microdurometer baq gmbh mod. alphadur 2
  • - 2 metallographic cut off saws
  • - Mounting press for metallographic test samples
  • - Automatic polisher for metallographic test samples